3D Home >>Security Products >> Cell Phone Jammers >> CJATM30

Cell Phone Jammer CJATM30

The cell phone jammer pictured to the right doesn't stand out, but that's the point. The CJATM30 cell phone jamming device is a "camouflage" unit that is designed to blend in to its surroundings. People will hardly notice it's there.

Conventional cell phone jammers look similar to a car stereo amplifier.  Usually, there are four rubber omni-directional antennas connected to the top and they must be installed in a central location.  In addition, conventional cell phone jammers usually must be concealed because they would draw a lot of attention if left exposed.  The Camouflage cell phone jammers address all those concerns.  All you see is a square tile mounted to the wall.  The antennas are built-in and incorporate a panel antenna design.  The jamming signal is broadcast only in front of it and will reach a distance of up to 50~60 meters.  The width of the jamming signal is designed to cover an entire room.

The CJATA30 is a professional cell phone jammer, engineered to be ON for 24 hours per day and even 365 days per year.  Lower quality products will over-heat and cannot be left ON continuously.  It also comes with an infra-red remote control that gives you the option to turn the power ON/OFF from a distance of up to 26-feet.  All cell phone jammers from 3D Wireless & Security can be tuned to match the cellular phone frequencies groups of almost any location in the world. 

This is an excellent option for institutional use in correctional facilities or other secure environments where a more obvious device would be more likely to be noticed and damaged. This cell phone jammer blocks cellphone signals at a distance of 50~60 meters in front of the jammer.

Cell phone jammers are ideal for use by SWAT teams, bomb squads, drug enforcement task forces, prisons and court rooms. By blocking cellphone signals, they can also thwart the remote detonation of bombs that are triggered by a call to the cellphone.

Specifications:

  1. TX frequency 869/851 ~ 894 MHz
  2. TX frequency 925/935 ~ 965 MHz
  3. TX frequency 1800 ~ 1990 MHz
  4. TX frequency 2110 ~ 2170 MHz.
  5. Cover interface standards: AMPS,N-AMPS, NMT,TACS,GSM,CDMA,TDMA,IDEN,UMTS.
  6. Total output power: EIRP 30W
  7. Patch Antenna - integrated Gain of 5 dBi for each band
  8. Designed to cut off wave in the down-link band width only. This will not interfere with the base station or the repeater tower.
  9. Jamming range: 50-60 meter diameter. The signal intensity must <-80db in the location.
  10. Jamming Pattern: 80° horizontal & 60° vertical
  11. Polarization: Linear
  12. Automatic power switching power supply: 50/60Hz/AC 100 ~ 240V to DC 12V
  13. Remote Control: Approximately 8 meter range.
  14. IP68 Waterproof Housing Outdoor design
  15. Device Dimension: 28.5(L)×27(W)×9.5cm(H)
  16. Device Weight: 2.5kg
  17. Operating temperature: -10℃ ~ +60℃
  18. Storage Temperature: -30℃ ~ +70℃
  19. Humidity: 95% non-condensing
  20. Inner hand carry Box: 39.5 x 33 x 17cm / Weight 3kg

Documentation

Specification Brochure

Photo Gallery

Click on any image for a larger view.

Front Panel View Rear Mounting Panel View Side View Cables and Infrared Remote

 


3D Home >> Security Products >> Cell Phone Jammers >> CJATM30

 
All contents ©2007~2008 3D Wireless & Security

This website and its contents are the property of 3D Wireless & Security.
Reproduction in whole or in part is strictly prohibited without the written permission from 3D Wireless & Security.

For other communication products, see 3Dimension.com